SLT-001 ARM HANDLE KIT INSTALLATION INSTRUCTIONS

  2. Remove hopper from machine.

  3. Facing the machine on the right side measure five (5) inches from back and six (6) inches from bottom. Drill 1¼ inch hole, taking care to be sure that the hole is straight.

  4. Install bronze bushing (#1779) on the inside of 1¼-inch hole. See Figure #1.

  5. Place mounting place (#SLT-003) with t-bar assembly (#SLT-009) on the outside of the machine. See Figure #2.

    6.  

  6. Drill 5/16-inch carriage bolt holes one at a time, inserting bolt (#1794) in each hole as you go. This will ensure proper hole alignment. See Figure #3.

    7.  

  7. Remove bolts, mounting plate and t-bar assembly.

  8. Put mounting plate (#SLT-003) with t-bar assembly (#SLT-009) on the inside of machine. Install carriage bolts (#1794) with lock washers (#1789) and nuts (#1790). See Figure #4.

    9.  

  9. Install spring (#SLT-008) and lock in with additional nut (#1790).

    10. See Figure #5.

     

  11. Install handle assembly (#SLT-010) into plastic cap (#SLT-006) and align threaded hole in handle with hole in plastic cap and insert round head screw (#1787) and tighten with screwdriver. See Figure #6.

    12.  

  12. Install micro-switch (#1781) with two sheet metal screws (#1791).

    13. See Figure #7.

  13. Install wires onto the micro-switch. Normally, wires should be installed to the normally open configuration on the micro-switch (#1781). See Figure #8.

    14.  

  14. Install wires to start knob assembly on the machine. Most start knob assemblies are of a three-wire type. Determine which wires are connected to the start knob and follow them to the circuit card above the start knob assembly. Turn on the machine; coin the machine up to be ready to spin the reels then short out the second and third posts briefly, use a screwdriver or jumper wire. This should start the reels spinning. If it does, then attach the two wires from the micro-switch (#1781) to the two wires you just shorted out. Attach the wires with the two (#1801) wire connectors. Notice one side of the (#1801) wire connector is open; insert the wire from the start knob assembly into the open side of the wire connector and the wire from the micro-switch (#1781) into the other side. Then crimp the connector with a pair of pliers; this should secure the wires in the connector. Then connect the second wire into the second (#1801) wire connector. NOTE: If you have trouble finding the right wires, contact the company you purchased the kit from for assistance.

  16. Install the extra nut (#1790) and vinyl tube (#SLT-007) onto the front lower carriage bolt (#1794). See Figure #9.

 

Your machine should now work with the start knob or the arm assembly.